OWNER’S MANUAL 1450 Lakeside Drive• Waukegan, Illinois 60085 USA 330-677-4424 • 800-321-6699 • Fax: 330-677-4471 http://www.etasys.com E-mail eta@etasys.com All designs and specifications are subject to change without notice. Copyright © 2006 ETA Systems.
Read and understand all of the instructions before connecting unit to wall supply. Lisez les consignes ci-dessous avant de connecter l'appareil au secteur. Gelesen und begreife das handbuch bevor anschliessend einheit bis wand nachschub. Legemmo e capiamo tutta istruzioni prima collegamento a muro fornirle. Always disconnect power cord before opening unit. Déconnectez toujours le cordon d'alimentation avant d'ouvrir le boîtier. Entferne gewalt schnur bevor aufgehend einheit.
SPECIFIC FEATURES FOR MODELS: FEATURE LIGHT SWITCH EPD11LIEC-CE, EPD11LVIEC-CE, EPD11LOIEC-CE LIGHT TUBES EPD11LIEC-CE, EPD11LVIEC-CE, EPD11LOIEC-CE VOLTAGE DISPLAY EPD10VIEC-CE, EPD11LVIEC-CE CIRCUIT BREAKER EPD10IEC-CE, EPD10VIEC-CE, EPD11LIEC-CE, EPD11LVIEC-CE POWER SWITCH EPD10IEC-CE, EPD10VIEC-CE, EPD11LIEC-CE, EPD11LVIEC-CE (1) FRONT PANEL IEC320 OUTLET EPD11LIEC-CE, EPD11LVIEC-CE, (1) BACK PANEL IEC320 MALE INLET EPD10IEC-CE, EPD10VIEC-CE, EPD11LIEC-CE,EPD11LVIEC-CE, EPD11LOIEC-CE (10)
LAMP REPLACEMENT REMPLACEMENT DE LA LAMPE LAMPE ERSATZ LAMPADA CAMBI 1. Disconnect the units power cord from the voltage source. Déconnectez le cordon d'alimentation du secteur. Loskomme das einheiten gewalt schnur vom stromspannung quelle. Disinnestano gli units potenza spago dai voltaggio fonte. 2. Remove screws on cover, and remove cover. Retirez les vis et ôtez le couvercie. Entferne schraubt an abdeckung, und entferne abdeckung. Allontanano vites su coperchio, e allontanano coperchio. 3.
EU DECLARATION OF CONFORMITY Information Technology Equipment Directives covered by this Declaration: 89/336/EEC Electromagnetic Compatibility Directive 73/23/EEC Low Voltage Direction Product: ETA Systems - "EPD11LVIEC-CE Series" Power Distribution Series, Serial Numbers CE20000+ (+ means "and up") Standard which Product Conforms to: IEC950-1, -2, and referencing -3:1995, or EN60950-3:1995 with all amendments through Jan. 1997.