Technical data
Flow meter FC01-Ex Flow meter FC01-Ex
Examples 69 Examples 69
Trim point V [m/s]
1.80
1.60
1.40
1.20
1.00
0.80
0.60
0.40
0.20
0.00
10
9
8
7
6
5
4
3
2
1
Y
35400
35267
35158
35063
34890
34668
34347
33846
32957
24635
Trim point V [m/s]
1.80
1.60
1.40
1.20
1.00
0.80
0.60
0.40
0.20
0.00
10
9
8
7
6
5
4
3
2
1
Y
35400
35267
35158
35063
34890
34668
34347
33846
32957
24635
V [m/s] Test data
1.94
1.67
1.38
1.18
0.99
0.80
0.61
0.42
0.21
0.01
-7.78
-3.89
1.11
1.11
0.56
0.00
-0.56
-1.11
-0.56
-0.56
Deviation [%MBE*]
Trim point V [m/s]
1.80
1.60
1.40
1.20
1.00
0.80
0.60
0.40
0.20
0.00
10
9
8
7
6
5
4
3
2
1
Y
35400
35267
35158
35063
34890
34668
34347
33846
32957
24635
Trim point V [m/s]
1.80
1.60
1.40
1.20
1.00
0.80
0.60
0.40
0.20
0.00
10
9
8
7
6
5
4
3
2
1
Y
35400
35267
35158
35063
34890
34668
34347
33846
32957
24635
V [m/s] Test data
1.94
1.67
1.38
1.18
0.99
0.80
0.61
0.42
0.21
0.01
-7.78
-3.89
1.11
1.11
0.56
0.00
-0.56
-1.11
-0.56
-0.56
Deviation [%MBE*]
Before quitting the submenu, the calibration data shall be permanently stored by pressing M.
Verification of the solution
In order to verify the curve determined, again set the flow velocity at the various trim points and
compare it to the values indicated by the FC01-Ex during the measuring operation.
Test values are:
The verification of the trim points indicates that trim point 10 is outside the tolerance required.
One of the reasons may be that the flow velocity varied when point 10 was set.
To increase the accuracy at a velocity of 1.80 m/s, that trim point should be redetermined.
* MBE = upper measuring range value
Before quitting the submenu, the calibration data shall be permanently stored by pressing M.
Verification of the solution
In order to verify the curve determined, again set the flow velocity at the various trim points and
compare it to the values indicated by the FC01-Ex during the measuring operation.
Test values are:
The verification of the trim points indicates that trim point 10 is outside the tolerance required.
One of the reasons may be that the flow velocity varied when point 10 was set.
To increase the accuracy at a velocity of 1.80 m/s, that trim point should be redetermined.
* MBE = upper measuring range value