Quick start Guide

ManualsBrandsETC ManualsContinuous LightingSource Four LED Series 2 Daylight HD with Shutter Barrel

ETC Source Four LED Quick Guide

Features

Source Four LED Profile Page 6 of 8 Electronic Theatre Controls, Inc.

DMX Profiles

Lustr+, Series 2 Lustr, Series 2 Daylight HD, Series 2 Tungsten HD, and Studio HD

DMX

Profile

DMX

Channels

Channel Assignments Notes

Direct 10

See

Channel

assignments in direct

mode

chart below

Direct control of each individual color with a

separate master intensity channel. Color

calibration of LEDs is not active in this mode.

The ten-channel profile will produce the highest

quality color cross fades.

RGB

(Ch. 4 not

used)

1-Red

Effectively addresses all seven colors via three

channels of control. RGB profile will produce

medium quality color cross-fades

2-Green

3-Blue

4 - n/a

5 - Strobe

6-Fan Control

HSI 6

1 – Hue (coarse)

High resolution hue (two channels), saturation,

and intensity control.

HSI mode will produce color cross-fades around

the color space.

2 – Hue (fine)

3 - Saturation

4 - Intensity

5- Strobe

6-Fan Control

HSIC 7

1 – Hue (coarse)

High-resolution hue, saturation, and intensity

control as above, with the addition of a color

point channel to adjust the color temperature of

the fixture in both white light and color. Color

cross-fade performance is the same as HSI.

2 – Hue (fine)

3 - Saturation

4 - Intensity

5 - Strobe

6 - Fan Control

7-Color Point (CCT)

Studio

(Ch. 4 not

used)

1 – Intensity

Controls fixture as a white light unit. If no DMX

is present, (i.e. console input), a fixture can be

adjusted for these three parameters on the U/I

at the back of the unit.

2 – Color Point (CCT)

3 - Tint

4 - n/a

5 - Strobe

6 - Fan Control

Additional profile options (on following page)

Plus 7

Seven additional precision color-control override channels are available for

use with RGB, HSI, and HSIC input profile settings. For example HSI with

‘Plus 7’ enabled becomes an 15-channel profile:

See

Plus7 profile

options

chart below

The desired color and intensity are achieved by

using the HSI or RGB channels

Placing the Plus7 channel at a value over 51%

gives the fixture additional channels in its profile.

Channels 9-15 represent the native colors of the

fixture and allow the operator to adjust individual

color channels to fine tune the color output.

Strobe

Variable strobe control: 0% is no strobe. The fixture output will strobe more

rapidly as the strobe channel value approaches 100%.