Owner manual

ETC
®
Install Guide
ES1 Dimmer Bracket and Connector Installation CE
ES1 Dimmer Bracket and Connector Install Guide Page 1 of 2 Electronic Theatre Controls, Inc.
Corporate Headquarters  3031 Pleasant View Road, P.O. Box 620979, Middleton, Wisconsin 53562-0979 USA  Tel [phone]  Fax [phone]
London, UK  Unit 26-28, Victoria Industrial Estate, Victoria Road, London W3 6UU, UK  Tel [phone]  Fax [phone]
Rome, IT  Via Pieve Torina, 48, 00156 Rome, Italy  Tel [phone]  Fax [phone]
Holzkirchen, DE  Ohmstrasse 3, 83607 Holzkirchen, Germany  Tel [phone]  Fax [phone]
Hong Kong  Rm 1801, 18/F, Tower 1 Phase 1, Enterprise Square, 9 Sheung Yuet Road, Kowloon Bay, Kowloon, Hong Kong  Tel [phone]  Fax [phone]
Service: (Americas) [e-mail]  (UK) [e-mail]  (DE) [e-mail]  (Asia) [e-mail]
Web: www.etcconnect.com  Copyright © 2013 ETC. All Rights Reserved.  Product information and specifications subject to change.
7145M2121  Rev C  Released 2013-02  ETC intends this document to be provided in its entirety.
Connector Options
The ES1 is a bare end dimmer for use with non-ETC, or preexisting fixtures. ETC recommends the
following for field installation.
Recommended CE 230V Input Connectors:
• 16A CEE 1PNE
• Schuko plug with earth connection
• UK13A mains connector
• UK15A round-pin connector
Recommended CE 230V Output Connector:
• White CEE 2P+E 16A connector
Connector Installation
Reference the input label of the dimmer for instructions on proper connector installation.
WARNING:
Risk of electric Shock! this equipment must be
earthed.
WARNING:
Reference the blue label attached to the dimmer’s output lead for important
output information.
This equipment outputs DC power and should be wired to a connector suitable
for DC power only. Do NOT use a standard mains connector.
WARNING:
The ES1 Dimmer can ONLY be wired to luminaires with tungsten lamps. Wiring
to any other lamp type will cause dimmer failure.
ES1 dimmer with bare end