Manual

2 The Retrofit 17

Finish Up

Step 1: Remove the CEM baffle from the spare CEM slot (if available). It is held by two

screws, one in each upper side corner, similar to the backplane screws. You

must bend the baffle to get it out of the spare module slot.

Step 2: Install the new CEM3 baffle into the spare module slot using the screws and

collars provided in the kit.

Step 3: Install the rack filter

door(s) on the rack by

pushing down on the tab

in the hinged corner and

sliding the door back in

place.

Step 4: Reinstall the left side of

the rack with the original 10 screws.

Step 5: Remove the old Sensor sticker from the

appropriate door.

Step 6: Apply the new Sensor3 sticker to the

door.

Step 7: Dispose of all waste materials in a safe

manner per local ordinances.

Verify the Retrofit

Step 1: Put the dimmer modules back in the rack in the correct/original order.

Step 2: Put the CEM3 in the rack making sure it is fully seated.

Step 3: Power up the rack.

Step 4: Check that the CEM3 powers up and the rack fan turns on. (The only rack errors

should be a lack of DMX on the ports if the DMX source is not present.)

Configure the CEM3

Step 1: Configure the rack to reflect the dimmer module types installed. Verify that the

rack type is correct (CEM3 should have determined this from the DIP switch

settings - see Backplane Settings, page 12) Configuration of the CEM3 is done

using the front face panel interface. See the CEM3 Quick Guide that ships with

the CEM3 for more information.

Step 2: Configure the data types that will be used (DMX and sACN) including the rack

patch.

Note:

Use caution when starting the six screws

along the outer edges, being careful not

to damage the spring retaining clips.

1-Push

stal