Designer v1.11.0 Instruction Manual

Unison Mosaic Designer User Manual
Use the Select Controller pull-down to view the Controller of interest, the verbosity (detail) of the log can be
changed using Controller configuration.
I get a "Magic number does not match" error when opening a project file?
You are trying open a project file that was created and saved with a later major version of Designer, for example
using Designer v1.1.x to open a file created with v1.2.x. While we endeavour to maintain backward compatibility
with files saved with earlier versions, progress requires that we sometimes make architectural changes going for-
wards. Reinstall the later version.
I get loads of warnings about custom fixtures when opening a project file?
You are trying to open a project that contains custom fixtures with the same identification number as custom fix-
tures already on your PC. Either delete the custom fixtures on your PC or give them different identification num-
bers. This has been fixed in v1.2.3 so please contact support if you still see these warnings.
I have forgotten the Controller's password?
You will need to go on site and gain access to the Controller then contact support for further instructions.
I have checked the FAQ and troubleshooting but I'm still stuck?
Contact support, please be prepared to send in your project file.
When using DMX In on a MSC or AVC, is my DMX line terminated?
No. To terminate the DMX line you should add a 120 Ohm resistor across the positive and negative terminals.
- 192 -