Installation guide

VCC-28 Installation Guide with WAVE Page 11 of 33 Essential Trading Systems Corp.
Num Lock mode Key Chart
The functionality of the VCC-28 keys in Num Lock mode (the Num Lock key is illuminated) is
shown in Table 1. The number keys (1 through #) function as a normal key pad.
Key Label Programming Function
1 1 1
2 2 2
3 3 3
4 4 4
5 5 5
6 6 6
7 7 7
8 8 8
9 9 9
0 0 0
* *
Numpad *
# # Left Shift 3
Head Set
Hardware Key
Toggles Head Set: Enable –or- Disable
Num Lock
Hardware Key
Toggles Number (1 - #) Keys: Numerical –or-
Programmed Hot Key
Phone Only
Hardware Key
Toggles Audio Input: USB audio disabled with phone
audio only routed to head set –or- USB audio summed
with phone audio routed to head set. Disables xmit.
New Call Ctrl-Alt-Shift-x Dial/Answer a call
Dial Ctrl-Alt-Shift-w Initiates the dialing of a new call
PTT Ctrl-Alt-Shift-z INOP: Over-ridden by Num Lock function
Phone
Hardware Key
Toggles Phone Audio Routing: Phone audio routed to
handset –or- phone audio routed to head set
Mute Caller Ctrl-Alt-Shift-u Mute Caller
Mute Mic. Ctrl-Alt-Shift-t Mute Microphone for call
Busy Ctrl-Alt-Shift-s Stop taking incoming calls
Call Fwd Ctrl-Alt-Shift-r Forward incoming calls
Key Latch
Hardware Key
INOP: Over-ridden by Num Lock function
Xfer Ctrl-Alt-Shift-n Transfer a call
Join Conf Ctrl-Alt-Shift-o Add/Remove a call from conference
Clear Call Ctrl-Alt-Shift-p Release (hang up) phone
Hold Ctrl-Alt-Shift-q Place call on hold
Foot Pedal Ctrl-Alt-Shift-z INOP: Over-ridden by Num Lock function
Table 1