Instruction manual

Notes:
!Do not direct the remote sensor toward
any light source, such as direct sunlight
or strong fluorescent light as it may
cause the unit not to operate correctly.
!When other remote controls are used
nearby or when the remote is used near
equipment using infrared rays,
interference may occur.
!Placing an object on the remote control
may cause a button to accidently be
pressed changing a function and
shortening battery life.
!Do not cover the front of the DVD
receiver with tinted glass, as it may cause
interference with normal operation of the
remote control.
!Make sure there are no solid objects
between the remote control and the
remote sensor. This could prevent the
unit from receiving the signal.
!Do not spill water or put wet items on
the remote control.
!Never disassemble remote control.
OPERATING THE
REMOTE CONTROL
Battery Installation
1. Push down and out on the battery
compartment cover to remove it.
2. Insert the two "AAA" batteries into the
battery compartment of the remote control,
making sure the + and - signs on the batteries
and the inside of the battery compartment
match up.
3. Replace the battery compartment cover.
Notes:
Do not mix batteries from different
manufacturers or old with new. If the remote
control will not be used for an extended
period, remove the batteries immediately to
prevent damage-causing corrosion.
If battery leakage occurs, wipe the battery
liquid from inside the battery compartment,
and then replace both batteries.
Always replace both batteries at the same
time, using new, fully charged batteries.
The life expectancy of batteries may vary
depending on amount of use.
Using the Remote Control
Point the remote control at the remote sensor
on the DVD receiver. When the signal is
received from the remote, the unit will
function accordingly. The remote will operate
up to approximately 16' from the remote
sensor at an angle of around 30' in each
direction.
BATTERIES
INCORRECT USE OF BATTERIES MAY
CAUSE THEM TO LEAK, CORRODE,
OR EXPLODE.