User's Manual
Table Of Contents
- Table of Contents
- Specifications
- Safety Information
- Light Indicator Chart
- VeSync App Setup
- Configuration
- Functions
- Set Timer
- Away Mode
- Troubleshooting
- Warranty Information
- Customer Support
- Package Contents
- B-Create Schedule
- C-Create Schedule
- D-Create Schedule
- E-Create Schedule
- Create Schedule
- Product Diagram
- A-Create Schedule
- Product Requirements
- Wifi Indicator chart
- Intallation
- checking wires
- about the wires
- removing the old light switch
- installing the switch
- Indicator Lights
- Using the App
- RGB Light
- Maintaining Your Smart Dimmer Switch
- Customer Support
- Configuration
- WiFi Indicator
- Connection Schematic
- About the Wires
- Removing the Old Light Switch
- Installing the Smart Light Switch
- Installing the Smart Dimmer Switch
- VeSync App Setup
- Configuration
- Schedules
- Timer
- Smart Dimmer Switch Settings
- Share Your Smart Dimmer Switch
- Delete the Smart Dimmer Switch
- More Features
- Contact Customer Support
- Maintaining Your Smart Dimmer Switch
- Troubleshooting-1
- Warranty Information-1
- Customer Support-1
43
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. End users must follow the specific
operating instructions for satisfying RF exposure compliance. To
maintain compliance with FCC RF exposure compliance requirements,
please follow operation instructions as documented in this manual. This
transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter. This equipment should be installed and
operated with a minimum distance of 20 cm between the radiator and
your body. The availability of some specific channels and/or operational
frequency bands are country dependent and are firmware programmed
at the factory to match the intended destination. The firmware setting is
not accessible by the end user.
FCC Radiation Exposure Notice