User Manual

Instructions
Helpful Hints
Building on better living.
Changing The Battery
Locate the screws on the back of the tire pressure gauge.
Use a small screwdriver to remove the screws and back cover.
Locate the 3V battery, remove it from its place and replace it with a new
battery.
Take special care to place the battery with the correct polarity.
Replace the back cover and screws.
1 Year Warranty by Etekcity
Etekcity warrants all products to be of the highest quality in material,
craftsmanship and service for a minimum of 1 year, effective from the date
of purchase. Should you encounter any issues or have any questions
regarding your new product, feel free to contact our helpful Customer
Support Team. Your satisfaction is ours!
TEL: [phone]
Email: [e-mail]
Digital Tire Pressure Gauge
DIAGRAM
Specifications
Package Contents
Warnings
Know Your Tire Pressure Gauge
Building on better living.
Building on better living.
Handle
LCD Backlit Screen
ON/OFF/UNIT Button
Lighted Nozzle
Range: 0-150 PSI / 0-10 Bar / 0-10 Kg/cm2 / 0-1000 Kpa
Display: 21 x 10mm LCD display
Power: 3V Lithium coin cell
Operating Temperature: -5~50°C / 23~122°F
1 x Etekcity Digital Tire Pressure Gauge
3 x LR44 Batteries (Pre-installed)
1 x CR2032 Battery (Pre-installed)
Press the trigger to turn the tire pressure gauge on. The gauge will
display “0.0” on the LCD Screen.
Place the nozzle of the tire pressure gauge on the tire valve you wish to
measure. Press firmly to ensure a good seal and prevent air from
escaping.
Hold the gauge on the valve until the measurement display locks. It
should only take a second if you have a good seal.
Remove the gauge to easily read the pressure reading.
To change units, simply press the trigger to rotate through the four
available pressure units.
Tire pressure gauge will automatically turn off shortly after use. Manually
turn off the gauge by pressing and holding the trigger.
Do not use this product for applications outside of its intended use
Read and follow all instructions before use
IIn order to get a strong seal, place the nozzle directly onto the tire valve.
Putting the gauge on the nozzle from an angle could result in an inaccu rate
reading. Once the gauge is placed, firmly press the gauge straight down.