User manual

Transmitter

Receiver

LED Color

RED

GREEN

YELLOW

BLUE

PURPLE

CYAN

WHITE

Transmission Power Level on XT-Mitter PRO: Displays current transmission power (1) 2dBm (Lowest),

(2) 8dBm, (3) 14dBm, or (4) 20dBm (Highest). To change the transmission power level, use the “PA”

button located on the front panel. Recommended is P4.

The XT-Mitter PRO will start blinking RED (meaning transmitting signal) and all the Slave fixture(s) will

start blinking GREEN (meaning receiving signal). You will have up to 300 feet, line of sight of

communication with your XT

-Mitter PRO and the CUBEecho RGBWA. Please reference the DMX chart

below for information on the Channel Mode programs.

Helpful Trick: To Master Reset to Factory setting your CUBEecho, press Menu and Enter button at the

same time and hold for 5 seconds. The light will go into the following factory settings. AUTO color change

mode, DMX

Address back to

001, Channel mode back

to 6CH Mode

, Slave Mode, IR Disabled, Display on

for 60 Seconds, Manual Colors back to 255, and put all custom colors (A-E) back to 0 color settings on all

RGBWA.

Infrared remote control:

To use the IR remote control on the CUBEecho, first ENABLE the IR INFA located in the MENU selection.

Also, turn the fixture into a MASTER. To control the fixture you must aim the remote at the infrared

sensor located on the top of the fixture by the LEDs.

Remote Functions:

ON/OFF turn on/off the light, if you don’t need the light for a while, you could press OFF to save power

PRO Press to activate Auto or Fade program, press UP or DOWN to choose speed for Fade

SOU sound active mode press UP or Down to chose sound active mode 1 or 2

STRO strobe mode, press UP or DOWN to choose speed

SPEE speed for Auto program, press UP or DOWN

MAST master mode

SLAV slave mode

CH addr / channel

FULL all leds light up

SHUT all leds turn off

Red red color GREE green color BLUE blue color

WHIT white color AMBE amber color PINK pink color

ORG orange/yellow color GYAN cyan color PURP purple

CUBEecho RGBWA Eternal Lighting February 2014