Datasheet

Page 14 of 36

Step 8

Install the dust boot with

strike plate onto it. (Fig 8)

Step 6

Install batteries, and plug in the power

cable. Secure the back lock housing onto

the battery plate. Fasten with 2 screws.

Press both catch pin in and snap the rear

handle into drive shift (Fig 6)

Step 5

Attach the battery plate onto the door, with the rubber

gasket between the door and battery plate. Make sure the

power plug go through the hole on the plate. Secure the

battery plate with 3 screws; fasten to front lock fastener

extension post and upper fastener post (Fig 5) Note:

upper fastener post is optional.

Step 7

Place the override cylinder into front handle housing,

insert override key through the hole into cylinder.

Turn the override key 90° clockwise. Press both catch

pin in and snap the front handle into drive shift. Turn

override key 90° counter clockwise and pull the key

out. (Fig 7)