Installation guide

15
REMOTE CONTROLLER INSTALLATION
1. Crimp the fork terminals to the wires.
・Minimum 18AWG wire (No polarity)
・Maximum 100m long
2. Attach the fork terminal to the connector base of
the backside unit with two screws tight.
3. Put out wiring downward through the cable trench.
4. Attach the remote control on the wall with two
attached screws. (If you need to attach the remote
control to brittle, you should use the anchor plug.)
Connector base
@@@@@@@@@@@WARNING@@@@@@@@@@@
 DO NOT locate the remote controls where they may come into contact with water.
 DO NOT position the remote controls in the vicinity of chemicals.
 DO NOT position the remote controls over a cooker, grill or toaster.
 DO NOT position the remote controls where materials may spill onto them.
 PLEASE NOTE IF THE CONTROLS ARE TO BE FITTED TO A METAL SURFACE
AN INSULATION PLATE SHOULD BE PROVIDED BEHIND THE MOUNTING
POSITION.
REMOTE CONTROL WIRING
Use the fork terminals