Operation Manual

30
Installing the thermostat
Important the thermostat must not be
installed where it may be exposed to
the following:
• direct sunlight and draughts.
• extreme uctuations in temperature
or high air humidity.
The oor sensor should be mounted in a
spiral hose laid in the oor. The hose en-
dings should be sealed so that the oor
sensor can easily be replaced. All tubes
leading into the appliance box must be
sealed so that the air temperature sensor
cannot be aected by draughts.
Installation
Mount the thermostat in a 65 mm
standard appliance box.
1. Make sure the box is level with the wall.
2. Take o the front and frame by pres-
sing in the latch on the right-hand side
with a screwdriver or similar tool, as
shown in the illustration.
3. Connect power, voltage 230 VAC,
load and any oor sensor cable. Any
extension to the oor sensor cable
must be by means of high-voltage cur-
rent. Protective conductors for the