Installation Guide
4
5 WWW.ETISSL.COM
Please contact 1-855-384-7754 or further assistance.
Installation
1
Turning off the power
□ Make sure the power is turned off at the source to the
location where the LED downlight (A) will be installed.
□ Open the cover of the attached electrical box.
2
Preparing to wire the downlight
□ Remove one of the knock out holes in the electrical box for
wiring, based on the installation position.
□ Insert the conduit from the electrical source into the open
knock out hole, feeding the wires into the electrical box.
3
Making the electrical connections
□ Insert the hot and neutral (black and white) wires from the conduit
into the wire connectors of the same color wires in the electrical
box on the LED downlight (A).
□ Insert the ground wire from the conduit into the wire connector
attached to the green wire from the LED downlight (A).
□ If a 0-10v dimming circuit is available, insert the purple and gray
wires from the conduit into the wire connectors of the same color
wires in the electrical box on the LED downlight (A).
4
Positioning the LED downlight
□ Compress the spring clips and insert the LED downlight (A) into the
opening in the ceiling.
□ Once both clips are inside the opening in the cut-out, carefully
push the LED downlight (A) up into the ceiling until the trim is flush
with the ceiling surface.
NOTE: Select the preferred color temperature of the light before
pushing the LED downlight (A) into the ceiling.
Electrical Box
WARNING: RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off the
circuit breaker before removing an existing light fixture or installing the new one.
Part # DL-8-40-903-MV-D / Order # 53192211 can be installed into 5 in. and 6 in. housings.
Part # DL-8-40-902-MV-D / Order # 53189111 can be installed into 8 in. and 10 in. housings.
A
Knock out
holes
Installation (continued)
A
A
Color Temperature
Toggle Switch
Adjusting the Color Temperature of the Light
This LED downlight allows you to customize the color temperature of the light using four settings from soft white to daylight.
□ Choose your favorite correlated color temperature (CCT) from four options: 3000K, 3500K, 4000K, or 5000K.
□ Move the toggle switch on theside of the electrical boxon the LED downlight (A)to make your selection beforepushing the
LED downlight (A) into the ceiling.
NOTE: The factory setting for the correlated color temperature (CCT) is 3000K, which is the warmest white light.
3000K 3500K 4000K 5000K