Item # 53303161 USE AND CARE GUIDE LED 18IN WALL PACK
Table of Contents Table of Contents.....................................................................2 Safety Information...................................................................2 Limited Warranty.....................................................................2 Pre-Installation.........................................................................3 Tools Required........................................................................3 Package Contents.....................................
hammer Silicone sealant PACKAGE CONTENTS Part A AA BB CC DD EE Description LED 18in Wall Pack Mounting Screw (short) Screw stud Mounting Screw (long) Wire Connector Water joint Quantity 1 A 4 3 3 4 1 AA DD 3 CC BB EE
Installation Instruction Ø7 4 Drill the holes on the base plate, Please drill 3 holes on the wall, correspond A, B, C position on the base plate 1.38’’ Remove the upper cover from fixture by dismounting 2 screws according to A, B, C position 3-Ø6 BB A A 6.42’’ 3 2 Turn off the power before installation 6.42’’ 1 C B C B 14.76’’ 14.
Installation Instruction (continued) 5 Install the base plate on the wall by fixing 3 screws 6 CC 7 8 Connect the cables according to drawing. Hang the upper cover over the base plate, connect the driver output and optic input with fast connector. Put the cables from the wall through the conduit entry point, seal any gaps around the conduit entry point.
Maintenance instruction 4.1 4.2 4.3 4.4 Do Not use volatile solvent such as alcohol to clean the troffer. Use soft cotton cloth with suds to clean the troffer . Non-professional Do not attempt to take apart and repair the troffer . Please use the constant-current driver exclusively adaptive to the troffer, do not change the driver without permission . Environment requirement Operating temperature: -40 °F~113 °F.
2017.07.
