Instructions / Assembly

4
1
Installing using the MagnaMount™ mounting plate
□ Position the mounting plate (FF) against the underside of the cabinet where you want the fixture to be mounted and mark the
locations of the two screw holes with a pencil. Take the mounting plate (FF) down away from the cabinet once the location has
been marked.
□ Place a mounting screw (DD) into the hole on one end of the mounting plate (FF) and attach an O-ring (BB) to the end of the
mounting screw to hold it in place. Repeat with the second screw on the other end of the mounting plate.
□ If attaching to drywall instead of to the underside of a cabinet, drill pilot holes and tap in drywall anchors (EE) at the screw
positions.
□ Hold the mounting plate (FF) up to the cabinet, matching the screw positions to the locations marked on the underside of the
cabinet.
□ Use a power tool to tighten the mounting screw (DD) on each end of the mounting plate (FF).
□ Position the under cabinet light fixture (A) on the MagnaMount™ mounting plate (FF) and adjust the alignment as needed.
FF
DD
A
BB
WARNING: RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off
the circuit breaker before removing the existing light fixture or installing the new one.
If replacing a previous direct wire fixture, with power disconnected to the electrical box, remove the existing fixture. Make a sketch of how
the current fixture is wired (by wire color) or mark the wires with masking tape and a pencil so you will know how to properly reconnect the
wires to the new LED light fixture.
Mounting Options
This undercabinet light can be installed either by mounting directly to the underside of the wood cabinet with screws or by installing the
MagnaMount™ mounting plate and attaching the light to the magnetic.
Installation
FF