Instructions / Assembly

6
A
Back Plate
AA
EE
AA
A
Knock-out Holes
4
Making direct wire power connections
□ Remove the four screws on the back of the light fixture (A)
and open the back plate of the fixture.
□ Determine which knock-out hole in the back plate of the
fixture (A) will be closest to the power supply wire feed and
remove the knock-out.
□ Insert the threaded end of the strain relief (AA) through the
knock-out hole from the outside.
□ Feed the flexible whip or NM cable of the power supply
through the strain relief (AA) in the back plate of the fixture
(A) and tighten the clamp until it is secure.
□ Connect the hot and neutral (black and white) wires from
the power supply box to the same color wires from the
electrical box.
□ Connect the green wire from the power supply box to the
grounding wire from the electrical box.
□ Cover the wire connections using wire connectors and
electrical tape.
□ Tuck all wire connections into the wire compartment in the
light fixture (A) and reattach the back plate of the fixture
with the four screws removed earlier.
WARNING: Do not plug in the power cord when the fixture
is direct wired to the power supply to avoid a dangerous
situation.
Installation (continued)