Instructions / Assembly

6
7
Attaching the diffuser to the housing
□ Insert one end of the diffuser (B) into the end cap of the
housing (A) to the bottom of the limit part.
□ Push the other end of the diffuser (B) to the top of the
limit part on the opposite end cap.
□ Restore power to the electrical box.
□ Turn on the light switch to activate the fixture.
6
Attaching the housing to the ceiling
□ Drill a 1/8-in. pilot hole into the screw locations marked on the ceiling. You can also use an awl or nail to
dimple the screw holes.
□ Install a drywall anchor (DD) and a mounting screw (EE) in each drilled mounting hole, but do not tighten fully.
□ Align the 2 mounting keyholes on the housing (A) with the 2 mounting screws in the ceiling. Once the screw
heads are through the large ends of the keyholes, slide the housing until the heads of the screws slide into
the narrow ends of the keyholes.
□ Finish tightening the mounting screws (EE) until the fixture housing (A) is tightly secured to the mounting
surface.
NOTE: The drywall anchors (DD) are only to be used for mounting the fixture onto plaster or drywall surfaces.
A
B
Limit part
Installation (continued)
DD
AA
EE
A