Operation Manual

Audible signals
Audible signals have been introduced to help
indicate which operations the appliance is
performing:
– end of the washing programme,
– intervention of an alarm due to malfunction
of the appliance.
Factory setting: audible signals activated
It is possible to deactivate the audible
signals.
Deactivation/activation of the audible
signals
1. Press the On/Off button. The appliance
must be in setting mode.
2. Press and keep pressed the programme
selection/cancel button until programme
light A flashes and programme light B
comes on with a fixed light.
3. Press programme selection/cancel but-
ton again. The programme light A comes
on with a fixed light and programme light
B starts flashing. Wait until programme
light A goes off. The programme light B
goes on flashing and the End indicator
light is on with a fixed light. This indicates
that you have activated the function for
deactivating/activating the audible sig-
nals. The fixed light of the End indicator
light means that the audible signals are
activated.
4. To deactivate the audible signals, press
the programme selection/cancel button
again. The End indicator light goes off in-
dicating that the audible signals are de-
activated.
5. To memorize the operation, switch off the
appliance by pressing the On/Off button.
• To activate again the audible signals sim-
ply follow the above operations until the
End indicator light comes on.
First use
Before using your dishwasher for the first
time:
• Ensure that the electrical and water con-
nections comply with the installation in-
structions
• Remove all packaging from inside the ap-
pliance
• Set the water softener level
• Pour 1 litre of water into the salt container
and then fill with dishwasher salt
• Fill the rinse aid dispenser
If you want to use combi detergent
tablets such as: ''3 in 1'', ''4 in 1'', ''5
in 1'' etc... follow the instructions
given in "Use of detergent".
Set the water softener
The dishwasher is equipped with a water
softener designed to remove minerals and
salts from the water supply, which would
have a detrimental or adverse effect on the
operation of the appliance.
The higher the content of these minerals and
salts, the harder your water is. Water hard-
ness is measured in equivalent scales, Ger-
man degrees (dH°), French degrees (°TH)
and mmol/l (millimol per litre - international
unit for the hardness of water).
The softener should be adjusted according
to the hardness of the water in your area.
Your local Water Authority can advise you on
the hardness of the water in your area.
The water softener must be set in two
ways: manually, using the water hard-
ness dial and electronically.
Water hardness Adjusting the water hardness setting Use of
salt
°dH °TH mmol/l manually electronically
51 - 70 91 - 125 9,1 - 12,5 2 level 10 yes
43 - 50 76 - 90 7,6 - 9,0 2 level 9 yes
37 - 42 65 - 75 6,5 - 7,5 2 level 8 yes
29 - 36 51 - 64 5,1 - 6,4 2 level 7 yes
26