Operation Manual

452515

• Insert the ﬁ lter back as shown on the picture, and tighten by

turning it in clockwise direction. To ensure good sealing the

gasket surface (A) must be dirt free.

The washing machine automatically monitors the execution of particular functions during the

operation, and reports any detected failures.

In such cases signal LED’s start ﬂ ashing in certain sequence.

The ﬂ ashing sequence changes in accordance with the nature of the detected failure.

In some cases you may attempt removing certain failures yourself, so count the number of ﬂ ashes,

repeating after certain pauses.

The machine signals failures immediately after detecting them and stops the program, except for

heater failure, where the machine completes the washing program without heating water.

Failures:

2 - Two ﬂ ashes: door is not correctly closed

3 - Three ﬂ ashes: inappropriate water intake

7 - Seven ﬂ ashes: inappropriate water outlet.

In these cases, you will be able to remedy the failure by yourself (See Troubleshooting table).

1 - One ﬂ ash: temperature sensor failure

4 - Four ﬂ ashes: spinning sensor failure

5 - Five ﬂ ashes: motor failure

6 - Six ﬂ ashes: Heater failure

In these cases, turn off the machine, then turn it back on and repeat the program. If the failure

reoccurs, contact your nearest authorized service center. The LEDs will continue to ﬂ ash until the

machine is turned off.

Interferences from the ambient (for example electrical wiring) could induce signalization of different

faults. In such cases:

- switch the appliance off, and wait for a few seconds;

- switch the appliance back on and repeat the washing program.

If the fault repeats, call authorized service shop.

Warranty shall not apply in case of failures due to interferences from the environment (lightning

stroke, power supply circuit faults, natural disasters).

Failures