Operation Manual

Instruction for use Nova Instant HC
25
© ETNA Coffee Technologies b.v.
COFFEE TECHNOLOGIES
5 RESOLVING PROBLEMS
5.1 LCD display on the selection panel
If faults occur in the machine, the LCD display on the selection panel
will display a fault message.
5.1.1 Fault messages
Despite taking all precautionary measures, faults may occur in the
machine. In this case, a fault message is displayed. The table below
shows a number of faults that could occur and their causes and
remedies.
Fault message Cause Remedy
Fill container x Container x is empty Fill the container and reset the
fault message, see Filling con-
tainers
Empty waste bucket The waste bucket is full Empty waste bucket and clean
it, see Emptying waste bucket
Rinse brewing group Rinse the brewing group, see
Cleaning the brewing group
automatically
Cleaning the brewing group Cleaning the brewing group
manually, see Cleaning the
brewing group
Empty drip tray The drip tray is full Empty drip tray, see Cleaning
drip tray
Exact change Not enough change in money
changer
Pay with exact change
Drink switched off Selected drink not available Contact your supplier
Replace lime scale filter Filter has exceeded its service
life
Replace the filter
Boiler is heating up Boiler temperature is too low Wait until the boiler has heated
up
No water Water level too low Check the machine's water sup-
ply