Specifications

EATON Screw-In Cartridge Valves E-VLSC-MC001-E2 May 2015C-24.A
C
Where measurements are critical request certified drawings. We reserve the right to change specifications without notice.
Model Code/
Operating Data
Model Code
EHH - AMP - 702 - C - *
Operating Data
Mechanical
Housing PA6 glass-reinforced plastic
(conforming to UL-94HB). Color: gray
Mounting interface ISO 4400 (DIN 43650)
Cable clamp Pg9 screw type
Cable diameter Ø 5 to 10 mm (0.197 to 0.394” dia.)
Wire section 0,5 to 1,0 mm2 (20-17 AWG)
Temperature, ambient range -20° to +70°C (-4° to +158°F)
Mass 0,07 kg (0.154 lb)
Electrical
Connections
1 24V DC
2 OV (power and signal)
3 Positive command signal
4 Negative command signal
Power (input) supply 18 - 36V DC including ± 10% maximum ripple
ripple (peak-to-peak)
24V DC nominal
Absolute maximum voltage 40V
Max. power consumption 35W
including solenoid
Reverse polarity protected Yes
Short circuit protected Yes
Maximum output current 1,6A
Maximum output voltage typical Typically 1,5V below supply voltage
(1,6A output current)
Command signal
For output (LED on) 11 to 24V
For no output (LED off) 0V to 5V
Input impedance 10 KOhm ohms
Deadband adjustment range <100 - 1000 mA
Gain adjustment range 0.02A to 1,6A (maximum)
Dither adjustment range 0 to 500 mA
Ramp time 50 ms to 5s
PWM frequency 1200 Hz ± 10%
Dither frequency 120 Hz ± 10%
Protection IEC 529: IP67 (when correctly installed
with interface seal in place)
Fully short-circuit and reverse-polarity protected
Isolation to VDE 0110 Group “B”
Electromagnetic compatibility (EMC):
Emission EN 50081-2
Immunity EN 50082-2
.B