Specifications

ETQ
Eastern tools & equipment, inc. Tel: [phone] Web site: easterntools.com
OPERATING THE GENERATOR
STARTING THE ENGINE
Before starting the engine, verify that the
gasoline mix is full, and air filter is in place.
Also, disconnect any load from the AC
receptacle.
Figure 1. Disconnecting electrical devices
• Turn the fuel valve to the “On”
position (Figure 2).
Figure 2. Fuel Valve
• Place the choke lever in the
“CHOKE” position (Figure 3.).
Figure 3. Choke Positions
CAUTION! NEVER start or stop the unit with
electrical loads connected AND with the connected
devices turned ON.
Figure 4. Engine switch on position
• Turn the engine switch to the “ON”
position (Figure 4).
• Pull the recoil starter grip lightly
until resistance is felt, then pull hard.
Warning: Do not allow the starter
grip to snap back against the engine.
Return it gently (Figure 5.).
Figure 5. Recoil starting rope
Push the choke rod to the “OPEN” position
as the engine starts up (Figure 6).
Figure 6. Putting choke rod to “OPEN”
11