Specifications

ETQ
Eastern tools & equipment, inc. Tel: [phone] Web site: easterntools.com
Improper maintenance:
The life of an engine or your equipment depends upon the conditions under which it operates, and the care it receives. Some
applications, such as tillers, pumps, and rotary movers, are very often used in dusty or dirty conditions, which can cause what
appears to be premature, wear. Such wear, when caused by dirt, dust, spark pug cleaning grit, or other abrasive material that has
entered the engine because of improper maintenance is not covered by warranty.
This warranty cover engine related defective material and/or workmanship only, and not replacement or refund of the equipment to
which the engine may be mounted. Nor des the warranty extend to repairs required because of:
1. Problems caused by parts that are not original eastern tools & equipment, inc., parts.
2. Equipment controls or installations that prevent starting, cause unsatisfactory engine performance, or shorten engine life. (Contact
equipment manufacturer.)
3. Leaking carburetor, clogged fuel pipes, sticking valves, or other damage, caused by using contaminated or stale fuel. (Use clean,
fresh, lead-free gasoline.)
4. Parts which are scored or broken because an engine was operated with insufficient or contaminated lubricating oil, or and incorrect
grad of lubricating oil (check oil level daily or after every 8 hours of operation. Refill when necessary and change at recommended
intervals.) Engine damage may occur if oil level is not properly maintained. Read Operating & Maintenance Instructions.
5. Repair or adjustment of associated parts or assemblies such as clutches, transmissions, remote controls, etc., which are not
manufactured by Eastern Tools & Equipment, Inc.
6. Damage or wear to parts caused by dirt, which entered the engine because of improper air filter maintenance, re-assembly, or use of a
non-original air filter element or cartridge. Read Operating & Maintenance Instructions.
7. Parts damaged by over-speeding, or overheating caused by grass, debris, or dirt, which plugs or clogs the cooling fins, or flywheel are,
or damaged caused by operating the engine in a confined area without sufficient ventilation.
8. Engine or equipment parts broken by excessive vibration caused by a loosen cutter blades unbalanced blades or loose unbalanced
impellers, improper attachment of equipment to engine crankshaft, over speeding or other abuse in operation.
9. A bent or broken crankshaft, caused by striking a solid object with the cutter blade of a rotary lawn mower, or excessive v-belt
tightness.
10. Routine tune-up or adjustment of the engine.
11. Engine or engine component failure, i.e., combustion chamber, valves, valve seats, valve guides, or burned starter motor winding,
caused by the alternated fuels such as, liquefied petroleum, natural gas, altered gasoline’s etc.
Warranty is available only through service dealers, which have been authorized by Eastern Tools & Equipment, Inc., please contact
the place of purchase or Eastern Tools & Equipment, Inc. for a Service Dealer near you.
CALIFORNIA & USEPA EMISSION CONTROL WARRANTY STATEMENT
The U.S. Environmental Protection Agency (EPA), the California Air Resources Board (CARB) and Eastern Tools & Equipment, Inc. are pleased
to explain the Federal and California Emission Control System Warranty on your small nonroad engine. In California, new small nonroad
engines must be designed, built and equipped to meet the State’s stringent and anti-smog standards. Eastern Tools & Equipment, Inc. must
warrant the emission control system on your small nonroad engine for the periods of time listed above listed above provided there has been no
abuse, neglect or improper maintenance of your small nonroad engine.
Your emission control system may include parts such as the carburetor, or fuel-injection system, the ignition system and catalytic converter. Also
included may be hoses, belts, connectors and other emission-related assemblies.
Where a warrantable condition exists, Eastern Tools & Equipment, Inc. will repair your small nonroad engine at no cost to you including
diagnosis, parts and labor.
OWNER’S WARRANTY RESPONSIBILITIES
As the small nonroad engine owner, you are responsible for the performance of the required maintenance listed in your Owner’s
Manual. Eastern Tools & Equipment, Inc. recommends that you retain all receipts covering maintenance on your small nonroad
engine, but Eastern Tools & Equipment, Inc. cannot deny warranty solely for the lack of receipts or for your failure to ensure the
performance of all scheduled maintenance.
As the small nonroad engine owner, you should, however, be aware that Eastern Tools & Equipment, Inc. may deny you
warranty coverage if your; small nonroad or part thereof has failed due to abuse, neglect, improper maintenance or unapproved
modifications.
You are responsible for presenting your small nonroad engine to Eastern Tools & Equipment, Inc. distribution center as soon as a
problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.
If you have any questions regarding your warranty rights and responsibilities or request warranty service you should contact
either the place of purchase or Eastern Tools & Equipment, Inc., c/o Service Manager, Engine and Equipment Service Division.
29