User Manual

RF Exposure (OET Bulletin 65)
To comply with FCC RF exposure requirements for mobile transmitting devices, this transmitter should
only be used or installed at locations where there is at least 20cm separation distance between the
antenna and all persons.
This device must not be co-located or operating in conjunction with any other antenna or transmitter.
OEM Responsibility to the FCC Rules and Regulations
The Mini Bar Media Access Controller Module has been certified per FCC Part 15 rules for integration into
products without further testing or certification. To fulfill the FCC certification requirements the OEM of the Mini
Bar Media Access Controller Module must ensure that the information provided on the Mini Bar Media Access
Controller Label is placed on the outside of the final product.
The Mini Bar Media Access Controller Module is labeled with its own FCC ID Number. If the FCC ID is not visible
when the module is installed inside another device, then the outside of the device into which the module is
installed must also display a label referring to the enclosed module. This exterior label can use wording such as
the following:
“Contains Transmitter Module FCC ID: VFC054901”
or
“Contains FCC ID: VFC054901”
The OEM of the Mini Bar Media Access Controller Module must only use the approved antenna, which has
been certified with this module.
The OEM of the Mini Bar Media Access Controller Module must test their final product configuration to comply
with Unintentional Radiator Limits before declaring FCC compliance per Part 15 of the FCC rules.
Industry Canada Statement per Section 4.0 of RSP-100
The term "IC:" before the certification / registration number only signifies that the Industry Canada
technical specifications were met.
Section 7.1.5 of RSS-GEN
Operation is subject to the following two conditions:
1) this device may not cause interference, and
2) this device must accept any interference,
including interference that may cause undesired operation of the device.