User`s manual

1. Windows XP (all editions) - auto run.
2. Windows 2000 (all editions) – manually run is required.
3. Windows 98 (SE) – manually run is required.
Note: (Generic USB mass storage class driver (Microsoft) will be
requested –if you plan to use EtroLink™ based device recovery on
Windows 98, please prepare one in advance)
l NO Software installation Required
There is no requirement of installation or setup of any software on Windows
XP/2000 platforms.
l Steps for Using EtroLink™ Config Port (Windows XP OS )
1. Unplug the power cable from the IP camera.
2. Connect EtroLink™ and PC via the mini USB cable.
3. After 5 ~ 10 seconds, the “Disk drive” will be detected. The
detecting speed is determined by the processing speed of your PC.
4. A POP-UP dialog indicates “Config Wizard” being ready to run.