Product Instructions

EN Operation
04/2020 11 / 20
Operation
Configuration Instructions
How to set up Virtual cable
Read before starting
1. Tightening tools are equipped with trackers.
Each tightening tool has been associated to a tightening unit and is ready to run a Pset.
2. Trackers have to be declared in CONNECT.
3. The Master tracking base has to be set up with CONNECT.
4. Working spaces can be set up by using CONNECT or CVI CONFIG.
Note the MAC addresses of tracker and tracking base and keep them available.
The MAC address of the tracker is located on the front panel.
The MAC address of the tracking base is located on the label of the rear panel.
Declaring the tracker
Go to CONNECT.
Tap "Configuration > System > Peripherals > Tracking system > Trackers".
Tick the box Locating tracker.
Click the white box below to display the screen "MAC address".
Use the keyboard to enter the 6 last digits.
Tap this icon to validate.
How to set up the Master tracking base
Go to CONNECT.
1 - In case communication with CONNECT is via USB
Tap "Configuration > System > Peripherals > Serial/USB > USB".
Set the tracking system to USB 1 or USB 2 according to the physical configuration.
Tap "Configuration > System > Peripherals > Tracking system > Settings".
Tick the box "Enable tracking system".
Tap this icon to validate.
2 - In case communication with CONNECT is via Ethernet
Tap "Configuration > System > Peripherals > Tracking system > Settings".
Tick the box "Enable tracking system".
Select "Ethernet communication".
Enter the IP address of the tracking base (by default 192.168.5.151) .
Tap this icon to validate.
3 - Declare the tracking bases
Tap "Configuration > System > Peripherals > Tracking system > Tracking bases".
Tap this icon to add a tracking base.
Click "Tracking base name-1" to customize the tracking base.
Click the white box below to display the screen "MAC address".
Use the keyboard to enter the 6 last digits.
Tap this icon to validate.