Product Instructions
EN Installation
04/2020 9 / 20
1 Tracking base
2 CONNECT inside panel
3 External PoE injector
Plug an Ethernet cable to the PoE injector (in) and to the Ethernet port of the tracking base.
Plug an Ethernet cable to the PoE injector (out) and to CONNECT.
Installation
Before mounting the tracking base, refer to the instructions given in the chapter Read before installing [Page7] in
this manual.
1. Open the mounting screw access door located on the front panel of the tracking base.
2. Place the M4 Torx screw and the bracket (supplied) as shown below.
Tighten the screw by hand.
3. Run a Nylon cable tie (not supplied) through the bracket and fix it at the chosen location.
For example:
How to read indicators
Item Indicator Description
4 Power supply indicator This LED lights up in green and remains steady when the
power supply is correctly provided.