User guide

MODEL 2080 / 2081 TURNTABLE SERIES Turntable Installation Instructions

REV C – PN 399228

will lead to high voltage drop in the power conductors and cause

reduced starting torque and premature motor failure.

Connect the fiber optic control cable and install the power

connection according to the “Electrical Installation” section.

The fiber optic cable must be looped through the “P” clip installed

on the front panel. Failure to do so will increase the chance of

cable being accidentally pulled, thus breaking the fiber optic

connectors.

CAUTION Prior to energizing the unit, a qualified and licensed

electrical contractor should be used to install power lines, and the

installation should comply with all applicable regulatory agencies.

A dedicated circuit should be used, with the shortest distance

possible between the power source and the turntable.

CAUTION Keep all body parts away from the drive chain when

the turntable is energized.

Rotate the turntable using the controller to verify proper operation.

If necessary, remove the top section

Set the travel limits. The mechanical travel limits of the turntable

have been changed from previous models for user convenience,

ease of operation and safety. These limit adjustments are not

located on the side of the motor base enclosure.

CAUTION The limits must be set whether or not the soft limits

present in the controller are used. Failure to do so may cause

damage to occur due to overrun of the table in either direction.

To increase the amount of travel in either direction, turn the knob

in the direction indicated by the positive (+) sign. To decrease the

amount of travel in either direction you must turn the knob in the

minus (-) direction as indicated.

Archived 3/18/10