User Manual

Installation MODEL 2088 ELECTRIC POWERED TURNTABLE
6 © ETS-LINDGREN L.P. – JANUARY 2003
REV C – PN 399253

3/4“ pipe clamp ends
 3/4“ pipe (length depends on table size 6 ft. will cover most
tables)
 1-1/2“ C-clamps, qty 8
 Cutting Oil
 Syringe for applying conductive grease
 Grease Gun
 Vacuum
Concrete Pit Installations
 1/2“ hammer drill
 1/2“ x 12 “ masonry bit
 3/16" x 6” masonry bit
 1/4" x 1-3/4“ Tapcon Screws or equivalent
1. The turntable installation will vary based on the host location.
There are several installation options presented in some steps,
please select the one that applies to your location.
2. Uncrate all parts. Check all parts for any shipping damage.
Ensure a clear area is available to assemble the turntable unit
safely.
NOTE: Do not discard any packing material until the turntable
is fully assembled.
3. Verify that that fiber optic cable is long enough to reach from
the turntable to the control room. When working around the
table avoid stepping on the fiber optic connectors located at the
relay box.
4. If the turntable is to be installed in a pit, check pit depth and
inside diameter and compare measurements with the drawings,
for your turntable size, at the back of this manual.
The inner diameter of the receptacle pit should be as follows:
1.23 meter turntable = 50.44”
1.53 meter turntable = 62.25”
a. If you have a paneled floor, did not purchase the integrated
ground plate interface option, and are installing the
turntable into a pit in the ground plane a receptacle hole
must be cut in the floor panels.
Archived 3/31/10