Specifications

MODEL 2088 ELECTRIC POWERED TURNTABLE Installation

REV C – PN 399253

drill, 0.120 dia. drill bits, a #2 phillips bit, and some cutting oil.

Start the strip 1/8" below the surface of the flange at the end with

the hole closest to the end of the strip. Also start with the first 2

holes in strip in between the casters. Place a clamp about 2” on

either side of the hole on the strip in 4 places and then transfer drill

0.120 dia. holes into the aluminum floor flange and then screw in

the 6-32 x 3/8” thread rolling screws.

NOTE: Some of the pre-drilled holes in the strip will be in the path

of a caster. For these holes, casters will need to be removed by

taking out the center axle of the caster. Be careful not to lose any

washers or allow the washers to fall out.

NOTE: Be careful not to bend the stainless steel strip, this will

make it difficult to install properly. Do not let the stainless steel

strip come up above the top of floor flange since it may bend when

something heavy is rolled over it. It may be beneficial to be

slightly below the surface of the flange.

Continue installation around the turntable with the wear strip.

When you get to the end, you will need to cut the strip to length.

Let the strip overlap the fixed end, and using a square, mark a line

even with the fixed end. The gap of the 2 joints should be less than

1/16”. Deburr the cut. You will need to drill the last hole to match

the spacing on the other end of the wear strip.

GREASING CASTERS & BEARINGS

Using a synthetic grease, grease all casters. Mobil 1 synthetic is

recommended, do not use a lithium grease.

NOTE: Some casters may not have grease fittings. These will be

sealed bearings and will not require grease.

FINAL LEVELING OF TABLE

Lower all ½-13 leveling screws. Once the table is in place with the

floor flange and wear strip mounted, install all remaining screws

for the spacer plates and tighten. Once this is done, place shim

plates in the center of the turntable and insert leveling screws to

Archived 3/31/10