Manual

Appendix A: Model 2090 GPIB Command Reference Model 2090 Multi-Device Controller
2090 Command Set:
AIR Set flotation mode of an air flotation turntable
AUX Set auxiliary control(s) ON/OFF
AUX# Set an auxiliary control ON/OFF
AUX#? Query the ON/OFF state of an auxiliary control
CAL Set the encoder calibration for a device
CAL? Query the encoder calibration for a device
ERE Set the Device Dependent Error Enable Register
ERE? Query the Device Dependent Error Enable Register
ERR? Query the Device Dependent Error Register
N1 Set numeric mode 1 (1050/60/90 -- xxx)
N2 Set numeric mode 2 (2090 -- xxx.x)
OFF Set polarization offset for a standard tower
OFF? Query polarization offset for a standard tower
S# Select speed on two speed/variable speed device
S? Query speed selection on a two speed/variable speed device
SEP Set separation distance to EUT for bore sight tower
SEP? Query separation distance to EUT for bore sight tower
SK Seek specified target
SKN Seek specified target in negative direction
SKP Seek specified target in the positive direction
SKR Seek relative to the current position
SS# Set speed setting on a variable speed device
SS? Query speed setting on a variable speed device
TT Select turntable and type
TWR Select tower and type
TYP? Query device and type
UH Set horizontal upper limit
UH? Query horizontal upper limit
UV Set vertical upper limit
UV? Query vertical upper limit
IEEE 488.2 Mandatory Instruction Set:
*CLS Clear Status Register
*ESE Set Standard Event Status Enable Register
*ESE? Query Standard Event Status Enable Register
*ESR? Query Standard Event Status Register
*IDN? Query Identity
*OPC Arm Operation Complete Flag
*OPC? Query Operation Complete
*RST Reset
*SRE Set Service Request Enable Register
*SRE? Query Service Request Enable Register
*STB? Query Status Byte Register
*TST? Self Test
*WAI Wait To continue
100 © ETS-Lindgren– April, 2006
Revision G– P# 399199