User Manual

www.ets-lindgren.com
Manual Control of the EMCenter
31
Configuration Screen
Press Config to display the Configuration screen. The IEEE address of the
EMCenter can be changed here.
Sample Configuration Screen
 IEEE Board—Press Change to enable or disable the board
(if installed).
 IEEE Address—Press Up or Down to change the address
(if installed).
 IP Address—Press Change to set a new address.
 Gateway Address—Press Change to set a new address.
 Touchscreen Calibration—Press Calibrate Screen and follow the
on-screen instructions.
 Laser Protection Code—Press Change to enter or change a code.