User Manual

Commands in FM5004 Mode | 65
Appendix D: Commands in FM5004 Mode
Unsupported Commands in FM5004 Mode
The following commands are not supported in either the HI-6100 mode or the
FM5004 mode. In general, the HI-6100 Field Monitor does not have alarm or
analog output capabilities. Functions to adjust the LCD and the display have also
been removed.
ALARM FUNCTIONS
Alarm functions are not available on the HI-6100. These commands
are included for test software compatibility purposes only and have no
effect on the HI-6100. An error entry will be added to the
CONTROLLER COMMUNICATIONS error list.
Command
Response
Alarm Latch
Where m is equal to the alarm mode:
ALAT,m,0<LF>
Alarm Silence
Where m is equal to the alarm mode:
ALOE,m,0<CR><LF>
Alarm Lower Enable
—
Alarm Lower Value
Where m is equal to the alarm type:
ALOV,m,0<CR><LF>
Alarm Upper Enable
Where m is equal to the alarm type:
AUPE,m,0<CR><LF>
Alarm Upper Value
Where m is equal to the alarm type:
AUPV,m,0<CR><LF>