Operating instructions

12 ETS WAGO-Software
WAGO ETS Plug-in
Manual
2.0.0
3.2 Access to KNX Devices via ETS4
ETS provides the following options in order to access KNX devices within a bus
system:
• Serial, using the COM interface
• USB
• ETHERNET (“KNXnet/IP” or “KNXnet/IP Routing”)
The ETS4-equipped PC used for project design must be connected to a KNX
interface.
An interface can be configured in ETS4 via [Settings] > Communication >
[New]. This procedure applies to all selected connection types. Further
information can be found in ETS Help.
Figure 1: “New Connection” dialog
If the KNX IP Controller functions as a KNXnet/IP Router, you can connect it
directly to a standard ETHERNET interface on your PC using an RJ-45 cable.
In this case, the cable runs from ETHERNET to twisted pair and twisted pair to
ETHERNET via the KNX IP Controller (750-889) and the KNX/EIB/TP1
Modules (see also Section “KNXnet/IP Router Parameterization”).