Operating instructions

28 KNX/EIB/TP1 Module / KNX IP Controller Parameterization WAGO-Software
WAGO ETS Plug-in
Manual
2.0.0
• the infix (between basic name and suffix) for identification when nesting.
Table 11: Structure of the network variable name – long/short form
Langform
Short form
<Program name>.<Basic name>
<Basic name>
<Program name>.KNX<No>_<Basic name>
<Basic name>
<Program name>.M<No1>_<No2><Basic name>
<Basic name>
<Program name>.M<No1>_<No2><Basic name>[<No3>]
<Basic name>[<No3>]
<Program name>.M<No1>_<No2><Basic name>.<Suffix>
<Basic name>.<Suffix>
<Program name>.M<No1>_<No2><Basic name>. <Suffix>
<No4>]
<Basic
name>.<Suffix>[<No4>]
More information on the syntax of network variable names can be found in the
Section “ETS” > … > “Syntax of Network Variable Names.”
4.1.1.3 “Tools” Menu Item
The Tools menu item is only displayed for controller configuration.
Figure 14: “Tools” menu item
Table 12: “Tools” menu item
Menu Item
Description
Start CODESYS…
Start the WAGO-I/O-PRO software
*)
Web browser…
Start the web browser with the Web-based
Management (WBM)
**)
*)
Requirement: Correct path to the .exe file of the software, see Section “Find file path to WAGO-I/O-PRO”
**)
Requirement: Available connection to the controller.
Configure the IP parameters prior to CODESYS or web access!
To start CODESYS or the web browser via ETS, the IP parameters must be set
via Options > IP Parameters… (see Section “Setting IP Parameters”).
4.1.1.4 “Options” Menu Item
Figure 15: “Options” menu item – Controller example