Operating instructions

WAGO-Software KNX/EIB/TP1 Module / KNX IP Controller Parameterization 31
WAGO ETS Plug-in
Manual
2.0.0
Figure 19: “IP Controller” dialog – KNXnet/IP parameters of the KNX IP Controller
The KNX IP Controller needs an IP address for network integration. Various
options for assigning the IP address include “manual,” “BootP,” “DHCP.”
Use the [Scan IP] button to search the network for the IP address of the controller
specified by the MAC address. If no suitable device is found for the MAC
address, the device is marked accordingly. An automatic search is also performed
for the device after opening the parameters dialog.
Specify the MAC address in the IP parameters dialog!
The MAC address of the KNX IP Controller must be specified in the MAC
address field. The address is located on the back of the controller and on a self-
adhesive, tear-off label on the side of the controller.
4.1.1.5 “Help” Menu Item
Figure 20: “Help” menu item
Table 14: “Help” menu item
Menu Item
Description
Online help…
Activates online help.
About…
Displays information about the ETS Plug-in.