Operating instructions

WAGO-Software KNX/EIB/TP1 Module / KNX IP Controller Parameterization 33
WAGO ETS Plug-in
Manual
2.0.0
Table 16: “List of network variables” table
Table Column
Value
Description

/

Checkbox for enabling or disabling
visibility in the ETS.
No.
(Table row number)
Consecutive number of the table rows.
CO #
(Communication
object number)
Communication object number in the ETS'
topology. The communication object
number is assigned automatically.
Name
(Network variable
name)
The network variable name is taken from
WAGO-I/O-PRO (CODESYS) and is
preceded by the “program name.” With
the appropriate setting in the “View” menu
item, only the short name is shown; the
display of the program name is disabled.
Type
(Data point type
name or, if without
type, amount + unit
of data width)
Data point type name. If the data point has
no type, its data width is shown.
Send on reset
On/Off
If the controller is reset, this variable
automatically sends the current value on
the bus or not.
This function can be used to initialize the
specific group object.
Read on reset
On/Off
If the controller is reset, this variable
automatically reads the current value from
the bus or not.
This function can be used to initialize the
associated function block.
Timeout
(amount + unit)
The data point has a watchdog and expects
an update within the specified time.
Cyclic send
(amount + unit)
Time interval for repetitive cyclic send
operation.
Group
addresses
(x/x/x)
Assigned KNX group addresses.
A data point can be associated with
several group addresses, maximum 253
group addresses/assignments. Data points
and group addresses are associated in the
topology window of the ETS.
Checkbox for Visibility in the ETS
The checkbox at the beginning of the line for each list entry defines whether the
corresponding network variable in the ETS is visible as a communication object
and appears in the topology list.
Some of the current properties/values of the network variables, e.g., “Read on
reset,” can be edited in the area of the “Properties” tab (see Section “'Properties'
tab”).