Operating instructions

34 KNX/EIB/TP1 Module / KNX IP Controller Parameterization WAGO-Software
WAGO ETS Plug-in
Manual
2.0.0
Multiple selection is supported!
In order to change the properties of several network variables at the same time,
you can mark several lines in the “List of network variables” simultaneously. The
changes that you make in the “Properties” tab then apply to all network variables
marked in the list.
4.1.4 “Network Variables” Tab – EIB Datatypes
The “Network Variables” tab contains the “EIB datatypes” in the left-hand area of
the user interface. The tree structure displayed enables you to filter the “List of
network variables” by EIB datawidth, EIB datatypes or EIS types.
The EIB and EIS types represent the available data point types in the ETS. The
“List of network variables” only shows those network variables that correspond to
the data type you have selected.
The “EIB datawidths” tree node enables you to filter the network variables
independently by datawidth rather than the actual data type. This enables you to
also list the new datawidths without a type.
Figure 22: Selection of EIB datatype 9 xxx, corresponds to DPT_Value_Temp