Operating instructions

WAGO-Software KNX/EIB/TP1 Module / KNX IP Controller Parameterization 37
WAGO ETS Plug-in
Manual
2.0.0
Table 17: Properties of network variables
Designation
Explanation
Read / Write
Name
Description of the selected network
variable. If several network variables are
selected: empty
R
Startup behavior
Send on reset
checkbox
If the checkbox is checked, values are
updated after a device reset. The values
are updated with a voltage reset, the reset
of the node from the ETS and a software
reset of the IEC application.
RW
Read on reset
checkbox
If the checkbox is checked, the device
reads the current value from the bus after
a device reset.
RW
Timing behavior
Timebase
Conversion of the timebase to seconds
[sec.] or minutes [min.]. Only enabled if
the Cyclic send or Timeout checkbox is
selected
R/RW
Cyclic send
checkbox
If the checkbox is checked, the device
sends its value to the bus with the
defined interval.
R/RW
Timeout
checkbox
If the checkbox is checked and the
telegram is not updated within the
specified time, the device indicates a
timeout on the corresponding FbDPT
function block in the PLC. The data
point has a watchdog and expects a
program update within the specified
time.
R/RW
If you have made multiple selections in the “List of network variables,” the
properties of all selected network variables can be updated simultaneously.
Checkboxes in which the selected network variables are different are marked in
blue (see figure “Multiple selection for editing network variables”).