Operating instructions

WAGO-Software KNX/EIB/TP1 Module / KNX IP Controller Parameterization 39
WAGO ETS Plug-in
Manual
2.0.0
4.2 Associating Network Variables and Group
Addresses
The basic task of the ETS software is visualizing the associations of network
variables of the KNX Module or KNX IP Controller with group addresses in the
ETS and enabling them to be edited.
4.2.1 Creating Associations
Associations between communication objects and group addresses are created
using “drag & drop” in the ETS. To do this, click and hold down the required
network variable from the Topology area and drag it to the required group
address.
Invalid association attempts are detected and indicated.
Figure 28: Creating an association using “drag & drop”
Associated network variable sets the type for further associations!
If a group address is associated with a network variable, only additional variables
of the same type can be associated with the relevant group address.