Operating instructions

42 KNXnet/IP Router Parameterization WAGO-Software
WAGO ETS Plug-in
Manual
2.0.0
5 KNXnet/IP Router Parameterization
The first KNX Module behind a KNX IP Controller (and possibly behind other
non-KNX Modules) extends the function of the KNX IP Controller to a
KNXnet/IP Router. Any subsequent KNX modules operate in device mode.
The KNXnet/IP Router routes telegrams from IP to a twisted-pair cable and vice
versa.
The following section describes the steps for using the KNXnet/IP Router within
the ETS.
5.1 “IP Router” Dialog
Proceed as follows to parameterize the KNXnet/IP Router:
1. Right-click the IP Router in the Topology area of the ETS to open the
context menu of the KNXnet/IP Router.
2. Choose here Edit Parameters to open the “IP Router” dialog.
This opens the “IP Router” dialog:
Figure 31: “IP Router” dialog