Instructions / Assembly

Eucatex of North America
2500 Northwinds Parkway, Suite 685
Alpharetta, Georgia 30004
(678)-624-0160
Fax [phone]
www.eucatex.com.br
HOW MUCH DO YOU NEED?
1. Measure the perimeter of the room you’d like to panel.
Write down measurement in inches.
Length + Width X 2 = Perimeter
2. Divide that number by 48
Perimeter ÷ 48 =
3. To allow for cutting waste, multiply that number by five percent.
X 0.05 =
4. Add these two numbers together (2 & 3).
This is the total number of panels needed.
+ = Total number of panels
Note: When using cleaning materials, experiment with scrap paneling or spot clean in an inconspicuous area.
Eucatex is not responsible for any damage caused by non-recommended cleaning methods.
1/8” and 3/16” HARDBOARD panels should be installed over a suitable noncombustible backing such as gypsum
wallboard. Consult your local building codes for approved application. Be sure to read the instructions printed on
the back of each panel. Do not install Hardboard or Wood Fiber direct-to-studs in mobile homes.
Consult your local building codes for approved application. Be sure to read the instructions printed on the back of
each panel.
Material Safety Data Sheet (MSDS) containing potential physical and health hazard information is available by
contacting: Product Safety – [e-mail]
Care should be taken in installing panels to allow for space between panels and heat producing appliances and
ignition sources. Consult your local building code authority for guidelines and requirements.
i
Eucatex of North America customer service [e-mail]