Quick Start Guide

22
English English
23
3.5 Connect the Doorbell Wires to the Doorbell
Connect the wires to the terminals at the back of the doorbell, then tighten the terminal screws.
Wire can connect to any terminal.
What is required: Wires and Wire Nuts (Optional) / Video Doorbell / Philips-head Screwdriver
Extension Wires and
Wire Nuts (Optional)
Video Doorbell 2K
(Wired)
Phillips-Head Screwdriver
(User provides it.)
Note:
•
To prevent short-circuit, make sure the wires are not touching each other after connecting
them to the terminals.
•
If the wires are too short, use the extension wires and wire nuts provided to make them
longer. Use electrical wiring tape instead if there is no more space on the wall for wire nuts.
3.6 Mount the Doorbell on the Bracket
Align the doorbell on top and then snap it on the bottom.
3.7 Restore Power
Switch the master circuit breaker back to ON.
ON
ON
You’re all set!
If you want to detach the doorbell or recharge it, please refer to the corresponding sections.