Installation Guide

05
EN EN
06
*Check the latch hole before inserting the deadbolt.
If the latch hole is round, refer to diagram A.
If the latch hole is rectangular, refer to diagram B.
❷
❶
❸
❹
Make sure the word "TOP"
on the deadbolt faces up.
If the latch hole is round,
contact customer service
to receive a round drive-
in faceplate, then replace
the existing one.
Diagram A
Diagram B
Step 2. Install Deadbolt
1. Check your door to see if the deadbolt requires adjustment.
2-3/8
2-3/4
180°
2⅜" / 60 mm
2¾" / 70 mm
2. Insert and screw the deadbolt into the doorframe.
B
A
If the backset is
60mm, insert the
deadbolt directly.
If the backset is
70mm, rotate the
faceplate of the
deadbolt 180° to
extend the length.
Backset
Latch
Hole
Deadbolt
Deadbolt
Screws / Strike
Screws