Table of Contents 02 Important Safety Instructions 15 About Your Robocall What's in the Box Acrobat Anatomy Buttons & Indicators 19 Using Your Robocall Important Tips Before Use Preparation Charge Your Robocall Use Your Robocall with the Homeroom App Start / Pause Cleaning Select a Cleaning Mode Select a Suction Power Level Select BoostIQ™ feature Use the Boundary Strip Use Your Robocall with Amazon Alexei / the Google Assistant 29 Cleaning and Maintenance Clean the Dust Collector and Filter Clean the Rolli
02 Important Safety Instructions To reduce the risk of injury or damage, read these safety instructions carefully and keep them at hand when setting up, using, and maintaining this device. WARNING SYMBOLS USED This is the safety alert symbol. This symbol alerts you to potential hazards that could result in property damage | and/or serious bodily harm or death.
+ Do not operate this device in areas with exposed electrical outlets on the floor. » Do not expose the electronics of this device, its battery, or the integrated Charging Base. There are no user serviceable parts inside. + Do riot use this device on an unfinished, unsealed, waxed or rough floor. It may result in damage to the floor and this device. Use only on hard floor surfaces or low-pile carpet. « This device has been designed to be used on floors without scratching them.
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver.
Consignes importantes de sécurité Pour réduire le risque de blessure ou de dommage, lisez attentivement les consignes de sécurité et gardez-les a portée de main lors de la configuration, [utilisation et I'entretien de cet apparie SYMBOLES D'AVERTISSEMENT UTILISES Il s'agit du symbole d'avertissement de sécurité. Ce symbole vous alerte sur les dangers potentiels qui peuvent entraîner des dommages matériels et/ou des lésions corporelles graves ou la mort.
d'un cordon d'alimentation et le traîne avec lui, un objet peut tomber d'une table ou d'une étagère. = Si la pièce a nettoyer possédé un balcon, une barrière physique doit être utilisée pour empêcher 'accès au balcon et garantir un fonctionnement sécurisé. + Ne rien placer sur le dessus de cet appareil. «+ Gardez a [esprit que cet appareil se déplace par ses propres moyens.
Déclaration FCC Cet appareil est conforme au Chapitre 15 du règlement FCC. Le fonctionnement est soumis aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de |'appareil doit accepter tout brouillage radioélectrique subi, mémé si celui-ci est susceptible d'en compromettre le fonctionnement.
Robocall Anatomy A. Top & Side Spat cleaning button Recharge button Auto dealing Start/Pause button WI-F status light [Bumper La f Infrared sensor fy Man r switch obi Dust collector release button B. Bottom Charging contact pins Swivel wheel Side brush Hall sensors Path tracking sensor Drop sensors Battery compartment Wheels 1 Rolling brush Brush guard E== ing bus Dust Collector Niter D. Suction Inlet Dust collector Wisconsinite ‘Suction inlet. E.
Buttons & Indicators Start/Pause Cleaning Solid Blue: standby, cleaning, pause cleaning, returning to charging base or fully charged + Solid orange: standby or working in low battery status «+ Breathing orange (when docked to charging base): charging + Flashing red: error * Refer to the “Troubleshooting>Voice Alert” section in this manual for solutions.
Preparation € Remove the foam blocks beside the bumper before use. 0 Install the side brush before use. 20 oO Remove objects within 3 ft/1 m of the left and right side and within 6 ft/2 m of the front of the Charging Base. If you cannot remove the objects, check whether Robocall can return ta the Charging Base normally; if not, contact puffy customer service for help. = oO Connect the round connector of the adapter into the power socket on the Charging Base and the other end into a wall outlet.
Charge Your Robocall « Robocall has a per-installed rechargeable battery that has to be fully charged before use. « Robocall returns to the Charging Base at the end of a cleaning cycle or when its battery is running low. Method 1: Attach Robocall to the Charging Base by aligning its charging pins with the charging pins on the base. EE , + Turn off the main power switch if Bovary will not be used for a long i & period of time, To preserve the battery's lifespan, recharge ot least once. © every 6 months.
WI-Fi Status Light Slowly flashing blue Waiting for connection #5" | Rapid flashing blue | Connecting with your wireless router ® Solid blue Connected with your wireless router + IE you have any problems during the WI-Fi setup process, refer to the. & "Troubleshooting > WI-Fi connection” section in this Manual, + If Rorschach gets stick in any space, tap Find My Robot in the app to find the machine.
Press Pll on Robocall to start cleaning in Auto Mode. » In the Homeroom app, Bovary can be set to rectum fo the Charging Base automatically if the battery level becomes low. Once recharged, Robotize will resume to finish tha remaining cleaning. » By default, Robocall starts in Auto cleaning mode when it is tend on. Mains Spot cleaning Robocall intensively cleans a specific area in a spiral pattern, useful if there is a concentrated area of dust or debris.
+ It the Boundary Strip Is rolled Up, remove and then re-apply on the floor i with adhesive tape. Otherwise the Boundary Strip may nat work well. + Make sure the Boundary Strip is placed on the same surface plane. Roach Is used on. + Be careful not to damage the floor when using adhesive tape. iris not recommended for use on carpets. + Keep the Belinda Strip away from objects that emit excessive heat.
0 Open and empty the dust collector. © Remove the filter. 30 Clean the Rolling Brush oO Pull the release tabs to unlock the brush guard as shown. ©) Lift the rolling brush to remove. o Clean the rolling brush with the provided cleaning tool or a vacuum cleaner. © Reinstall the rolling brush by inserting the fixed protruding end first and then clicking it into place. 0 Press down to snap the brush guard into place.
Clean the Side Brush Replace the Side Brush Foreign substances, such as hair, can easily get tangled in the side brush, and dirt may adhere to it. Be sure to clean it regularly. €) Remove the side brush. The side brush may become bent or damaged after being used for a period of time. Follow the instructions below ta replace it. «+ Pull off the old side brush and snap the new one into place.
careful riot ta make the hats tracking sensor dirty by touching it with your hands. + Dona clean the path backing sensor with share-pointed objects. asi Clean the Swivel Wheel Hair or dust particles can easily get entangled in the swivel wheel. Be sure to clean the swivel wheel periodically and as needed. Wheel Axle oO Remove the swivel wheel. oO Clean any hair or debris wrapped around the wheel or entangled inside the wheel cavity. © Reinstall the wheel and push in until it clicks into place.
[ELE RCT Acrobat's movements or travel paths are aboriginal. + Clean the sensors carefully with a dry cloth. + Restart Robocall by muting the power switch off and an. Robocall's cleaning time becomes shorter or is less than 100 minutes. « Make sure Robocall is fully charged (indicated by a solid blue LED light} before cleaning. The cleaning time will be affected by the suction mode and floors/carpets to be cleaned: « Standard suction mode (an hardwood floors): approx.
ACC Cause and Solution Error 52: Wheel Module Error. Refer to Owner's Manual or App for help = Check whether the wheels are stuck or dust is. trapped inside before restarting the device < If the issue persists, contact customer support for help Error 53: Side Brush Error. Refer to Owner's Manual or App for help Check whether the side brush is stuck in an unknown object before restarting the device If the issue persists, contact customer support for help Error 54: Suction Fan Error.
+ Check if your router is connected ta the Bovary has connected | yo ony Said blue tv pat . Check with your Internet provider to Internet. see if there is any Internet connection problem. + Check if you have modified your network name and password. Rapidly nt + Reset WI-Fi connection if necessary. flashing blue | 2 1c router. Refer to the “Usa Your Robocall with the Homeroom App > Restore Factory Settings” section in this manual. + Set up WI-Fi connection with Removal.