Installation manual

Euphonix CO-600 Change-Over System For New Core DF66 Redundancy
Authorized Service Personnel ONLY:
Important Note!
Due to the “Hot Swap” capabilities of all card components in the COS chassis, power can be
applied to the unit at any time before after or during card installation. It is recommended,
however, that this feature only be used when necessary.
This is because the hot swap system can not protect from all possible errors made by the
operator during card installation.
Powered on cards are susceptible to damage from accidental shorting due to conductive
jewelry, excessive card deflection, or mis-aligned insertion or cards. To insert or remove
cards while the chassis power is applied, first carefully read instructions in this manual to
prevent damage to equipment.
This unit should be installed in restricted access areas only
(such as dedicated equipment rooms or equipment closets)