Instruction manual

Euphonix Max Air Mixing Console Operation Manual Channels and Strips
91
Backstop PFL
The Max Air faders have a backstop key past the bottom of their travel. Pull a fader
back to route the channel’s PFL signal to the solo bus. Releasing the fader cancels that
fader’s routing to the solo bus. Backstop PFL can be used on group masters to solo a
control group. See page 140 for more information.
5.2.3 Meters
The meter can show the active channel, or Main and Swap, and can also show gain reduction
in the bottom four LEDs on the right meter (see Meters on page 80). Stereo channels
display the left and right channels on the left and right sides of the meter, respectively.
5.2.4 Status LEDs
The following explanations pertain to the LED being illuminated.
• 48 V: phantom power is on for the mic preamp of the active channel.
•Phase: phase is inverted for the active channel.
• Lock: strip is locked (page 74).
•ST: active channel is stereo (page 149).
•Mix Minus: mix minus key is pressed (page 106).
• Fader Touch Sensor LED: fader is being touched.
•M: active channel is Group or Multi Format Master (Chapter 8: Control
Groups and Multi Format Masters).
•S: active channel is a slave to a Group or Multi Format Master (Chapter 8: Con-
trol Groups and Multi Format Masters).
•L: reserved for future use
5.2.5 Wave Key
Pressing the Wave key has two functions:
• brings the channel to the center Super Channel (see page 122).
• modifies other keys like a shift key.
5.2.6 Channel On Key
The On key turns the channel on and off.
Channel On Select Key
The Select key is used to include the channel On key in copy and clear operations.