Installation manual

Section 2: Automation Editing
2 - 6 Euphonix CS3000/2000 MixView 3.0 Software Supplement
On-The-Fly
Using Cue/Locate points
From the T/C menu press [F4] (Cue). Use the Numeric keypad, the [+]/[-] keys
or the SpinKnob to select a cue number from the cue list and press [Enter].
Again, use [F1] to toggle between “Start” and “End”. For detailed information
on the Locate/Cue system refer to the CS3000/2000 Operation Manual.
While in the T/C menu, toggle to “Start” and play the T/C source. At the
desired point in the program, press [Enter] in the Numeric keypad to capture a
timecode value. The menu will automatically toggle to “End”. Press [Enter]
again at the desired point to capture a timecode value. Should the start time
need to be updated, the menu must be manually toggled back to “Start” using
F1.
From the top-level Pass Control menu, the DSC Numeric [7] key enters a
“Start” value while the Numeric [8] key enters an “End” value.